Analog & Mixed Signal / power management IP Core

The present Power-On-Reset circuit generates system reset pulses (RST) when the 3.3V power supplier is turned on. The output signal RST33 is positive ...

152

1.0

IBM 65nm SF 3.3V/1.0V Power on Reset

The present Power-On-Reset circuit generates system reset pulses (RST) when both the 3.3V and 1.0V power suppliers are turned on. The output signal RS...

153

1.0

Active antenna detector with load current limit

The antenna detector supplies an active antenna and is able to detect both open and short circuits. A current limiter restricts the antenna current to...

154

1.0

Active antenna detector with load current limit and supply current 140 uA

The antenna detector supplies an active antenna and is able to detect both open and short circuits. A current limiter restricts the antenna current to...

155

1.0

Adaptive Body Bias Generator

The adaptive body bias generator (ABBG) consists of a positive-BBG and a negative-BBG for FDSOI-MOS transistors. The ABBG is used for either Reverse B...

156

1.0

LDO regulator in SMIC 40nm, 0.6~1.1v output

The present IP is a low dropout voltage regulator, which can support 10uA current load. The input voltage is 2.7-3.6V (typical: 3.3V). Its output volt...

157

1.0

LDO regulator in SMIC 40nm, 1.13v output

The present IP is a low dropout voltage regulator, which can support 10uA DC current load. The input voltage is 2.7-3.6V (typical: 3.3V). Its output v...

158

1.0

LDO regulator in SMIC 40nm, 1.42v output

The present IP is a low dropout voltage regulator, which can support 10uA DC current load. The input voltage is 2.7-3.6V (typical: 3.3V). Its output v...

159

1.0

LDO regulator in SMIC 40nm, 2.1v output

The present IP is a low dropout voltage regulator, which can support 360uA current load. The input voltage is 2.7-3.6V (typical: 3.3V). Its output vol...

160

1.0

LDO regulator in SMIC 40nm, up to 12mA

The present IP is a low-dropout (LDO) voltage regulator supporting a 12mA load current with an input voltage range of 2.7V to 3.6V (typical: 3.3V). It...

161

1.0

LDO regulator in SMIC 65nm, capless

The present IP is a low-dropout (LDO) and capacitor-less voltage regulator developed using SMIC's 65nm ETOX Nor Flash process. It generates adjustable...

162

1.0

Reference Voltage Generator, 1V Output, 2.5V external reference

Reference Voltage Generator, 1V Output, 2.5V external reference...

163

1.0

Regulator, 10mA, 1.8V - XFAB 180nm

Regulator, 10mA, 1.8V - XFAB 180nm...

164

1.0

Regulator, 50mA, 2.5V - IHP 250nm SiGe

Regulator, 50mA, 2.5V - IHP 250nm SiGe...

165

1.0

Regulator, Tunable, 10mA, 1.8V - XFAB 180nm

Regulator, Tunable, 10mA, 1.8V - XFAB 180nm...

166

1.0

Regulator, Tunable, 10mA, 2V - GlobalFoundries 130nm RFSOI

Regulator, Tunable, 10mA, 2V - GlobalFoundries 130nm RFSOI...

167

1.0

Regulator, Tunable, 10mA, 3V - XFAB 180nm

Regulator, Tunable, 10mA, 3V - XFAB 180nm...

168

1.0

Regulator, Tunable, 10mA, 4V - XFAB 180nm

Regulator, Tunable, 10mA, 4V - XFAB 180nm...

169

1.0

Regulator, Tunable, 10mA, Programmable 1.8V/0.4V - XFAB 180nm

Regulator, Tunable, 10mA, Programmable 1.8V/0.4V - XFAB 180nm...

170

1.0

Regulator, Tunable, 30mA, 3V - XFAB 180nm

Regulator, Tunable, 30mA, 3V - XFAB 180nm...

171

1.0

Regulator, Tunable, 50mA, 3.3V - IHP 250nm SiGe

Regulator, Tunable, 50mA, 3.3V - IHP 250nm SiGe...

172

1.0

Regulator, Tunable, 50mA, 4.8V - IHP 250nm SiGe

Regulator, Tunable, 50mA, 4.8V - IHP 250nm SiGe...

173

1.0

General Purpose PMU - Thermal shutdown and overvoltage protected SilTerra 0.18 μm

This macro-cell is a Power Management Unit (PMU) core designed for Silterra 0.18µm C18GH5 CMOS technology in TO (thick oxide) and HP (thin oxide) proc...

174

1.0

Retention Alternative Regulator, combines a linear regulator and an ultra-low quiescent regulator for sleep mode in TSMC 55uLP

RAR-iLR-qLR-ref-1.62-3.63-0.55-2.5.01_TSMC_55_uLP is a Retention Alternating Regulator in TSMC 55uLP combining two regulation sub-components: a linear...

175

1.0

Charge-Pump negative voltage generator with adjustable wide range on SMIC65nm

The present IP is a charge-pump voltage generator developed using SMIC's 65nm ETOX Nor Flash process. It generates high voltages ranging from -10.1V t...

176

1.0

Charge-Pump positive voltage generator with adjustable wide range on SMIC65nm

The present IP is a charge-pump voltage generator developed using SMIC's 65nm ETOX Nor Flash process. It generates high voltages ranging from 3.6V to ...

177

1.0

Charge-Pump positive voltage generator with LDO in-built on SMIC65nm

The present IP is a charge-pump and low dropout voltage generator, which is developed with SMIC 65nm ETOX Nor Flash process. And it generates 4.5~6v h...

178

1.0

HHGrace 0.18um 3.3v-1.8v Power Regulator

This IP is a Low-Dropout (LDO) 3.3V to 1.62 V power regulator with two channel 1.8V output. When it worksin regulation region, the maximum rated outpu...

179

1.0

HHGrace 0.18um 5v-1.125v Power Regulator

The Power Regulator is to provide 1.125v power supplies which are regulated from the single 5v input supply. This IP does not need any external cap. T...

180

1.0

HHGrace 0.18um 5v-1.8/3.3v Power Regulator

The Power Regulator is to provide both 3.3v and 1.8v power supplies which are regulated from thesingle 5v input supply. The maximum output currents ar...

181

1.0

Linear Regulator, Low Noise optimized for sensitive application such as RF or PLL blocks in TSMC 55uLP

nLR-Charny-ref-1.62-3.63-0.8-2.5.03_TSMC_55_uLP is a Low-noise LDO in TSMC 55uLP, tailored for RF....

182

1.0

Linear regulator, low-noise optimized for sensitive analog loads such as CODEC and Reference in SMIC 55LL

nLR-VAIPO-2.90-3.63-2.5.01_SMIC_55_LL is a low-noise linear regulator LDO in SMIC 55LL for sensitive analog blocks....

183

1.0

Linear regulator, low-noise optimized for sensitive analog loads such as CODEC and Reference in TSMC 55LP

nLR-VAIPO-2.90-3.63-2.5.01_TSMC_55_LP is a low-noise linear regulator LDO in SMIC 55LP for sensitive analog blocks....

184

1.0

Linear Regulator, ultra low quiescent current for retention mode in TSMC 40LP

qLR-Aubrey-ref-1.62-3.63-0.55-2.5.02_TSMC_40_LP is an ultra-low quiescent LDO (Linear regulator) in TSMC 40LP....

185

1.0

GLOBALFOUNDRIES 0.11um 3.3v-1.2v Power Regulator

Targeted in GLOBALFOUNDRIES 0.11μm 3.3v Logic process, current design of Power Regulator is to provide 1.2v power supply which is regulated from the s...

186

1.0

GLOBALFOUNDRIES 0.13um 3.3v-1.2v Power Regulator

Targeted in GLOBALFOUNDRIES 0.13um 3.3v Logic process, current design of Power Regulator is to provide 1.2v power supply which is regulated from the s...

187

1.0

GLOBALFOUNDRIES 22nm FDSOI 1.8v/0.8v Power Regulator

The Power Regulator is to provide 0.8v power supplies which are regulated from the single 1.8v input supply. This IP does not need any external cap. T...

188

1.0

GLOBALFOUNDRIES 40nm LP 2.5V/1.1V Power on Reset

The present Power-On-Reset circuit generates system reset pulses (RST) when both the 2.5V and 1.1V power suppliers are turned on. Output signal RST11 ...

189

1.0

GLOBALFOUNDRIES 40nm LP 3.3V-2.5/1.1V Power Regulator

This IP is a Low-Dropout (LDO) 3.3V to 2.5V and/or 1.1V power regulator in GLOBALFOUNDRIES 40nm LP 1.1V/2.5V process. When it works in regulation regi...

190

1.0

GLOBALFOUNDRIES 40nm LP 3.3V-2.5/1.1V Power Regulator

This IP is a Low-Dropout (LDO) 3.3V to 2.5V and/or 1.1V power regulator in GLOBALFOUNDRIES 40nm LP 1.1V/2.5V process. When it works in regulation regi...

191

1.0

UMC 0.18um 3.3v-1.8v 150mA Power Regulator

Power Regulator, also called Voltage Regulator, is an on-chip device which provides suitable power supply for the core by regulating the external high...

192

1.0

UMC 0.18um 5v-3.3v Power Regulator

Based on UMC 0.18um 3.3v/1.8v Logic Process, current design of a Power Regulator is to provide a 3.3v voltage output regulated from a 5v input supply ...

193

1.0

UMC 0.18um 5v-3.3v Power Regulator

Based on UMC 0.18um 3.3v/1.8v Logic Process, current design of Power Regulator is to provide the 3.3v voltage output regulated from a 5v input supply....

194

1.0

SMIC 0.13um 1.2V Power On Reset

Present Power on Reset generates system reset pulses (POR12) when 1.2V power supplier (VIN12) is turned on. This IP can not operate stand-alone becaus...

195

1.0

SMIC 0.13um 1.2V Power On Reset

Present Power on Reset generates system reset signal (POR12) when 1.2V power supplier (VIN12) is turned on. This IP can not operate stand-alone becaus...

196

1.0

SMIC 0.13um 1.8V Power On Reset

Present Power on Reset generates system reset pulses (POR18) when 1.8V power supplier (VIN18) is turned on. This IP can not operate stand-alone becaus...

197

1.0

SMIC 0.13um 1.8V Power On Reset

Present Power on Reset generates system reset signal (POR18) when 1.8V power supplier (VIN18) is turned on. This IP can not operate stand-alone becaus...

198

1.0

SMIC 0.13um 2.4V Power on Reset

The present Power on Reset IP generates system reset signal (POR18, low level reset) when 3.3v power supplier (VIN18) is turned on. This IP cannot ope...

199

1.0

SMIC 0.13um 3.3V Power On Reset

Present Power on Reset generates system reset pulses (POR33) when the 3.3V power supplier (VIN33) is turned on. This IP can not operate stand-alone be...

200

1.0

SMIC 0.13um 3.3V Power On Reset

Present Power on Reset generates system reset signal (POR33) when 3.3V power supplier (VIN33) is turned on. This IP can not operate stand-alone becaus...

...|